Dell PowerEdge C1100 - Manual (Page 61)

Installing System Components 61
Figure 3-8. Removing and Installing the Processor
7 Lift the processor out of the socket and leave the socket-release lever up so
that the socket is ready for the new processor.
CAUTION: Be careful not to bend any of the pins on the ZIF socket when removing
the processor. Bending the pins can permanently damage the system board.
Installing the Processor
NOTE: When installing only one processor, the processor must be installed in the
CPU0 socket (for the socket location, see "Jumpers and Connectors" on page 115).
NOTE: Your system uses an LGA 1366 socket, which is designed for trouble free
insertion of the CPU. After placing the CPU into the socket, press the lever down
and lock in place. If you notice any resistance when inserting the CPU, ensure that
it is aligned correctly
1 processor shield 2 processor
3 socket-release lever 4 ZIF socket
5 socket keys (2) 6 notch in processor (2)
2 1
6
3
4
5
book.book Page 61 Tuesday, February 26, 2013 11:33 AM