System battery, Removing the system battery – Dell PowerEdge C1100 User Manual
Page 94
94
Installing System Components
System Battery
Removing the System Battery
CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized
in your product documentation, or as directed by the online or telephone
service and support team. Damage due to servicing that is not authorized by Dell
is not covered by your warranty. Read and follow the safety instructions that
came with the product.
WARNING:
There is a danger of a new battery exploding if it is incorrectly
installed. Replace the battery only with the same or equivalent type recommended
by the manufacturer. See your safety information for additional information.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 55.
3 Remove the cooling shroud. See "Removing the Cooling Shroud" on
4 Locate the battery socket. See "System Board Connectors" on page 115.
CAUTION:
To avoid damage to the battery connector, you must firmly support the
connector while installing or removing a battery.
5 Support the battery connector by pressing down firmly on the positive side
of the connector.
6 Press the battery toward the positive side of the connector and lift it out of
the securing tabs at the negative side of the connector.
book.book Page 94 Tuesday, February 26, 2013 11:33 AM