System board, Removing the system board, See "system – Dell PowerEdge C1100 User Manual
Page 96
96
Installing System Components
System Board
WARNING:
Whenever you need to lift the system, get others to assist you.
To avoid injury, do not attempt to lift the system by yourself.
CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that
came with the product.
Removing the System Board
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2 Open the system. See "Opening the System" on page 55.
3 Remove the cooling shroud. See "Removing the Cooling Shroud" on
4 Remove all memory modules. See "Removing Memory Modules" on
5 Remove the expansion card-riser. See "Removing the Expansion-Card
6 Remove the heat sinks. See "Removing the Heat Sink" on page 58.
7 Remove the processors. See "Removing the Processor" on page 60.
8 Disconnect the power, IPMB, SATA, front panel, and system board cable
connectors from the motherboard.
CAUTION:
Do not lift the system board assembly by grasping a memory module,
processor, or other components.
9 Loosen the ten screws securing the system board, and then slide the
board back, up and out of the system. See Figure 3-27.
book.book Page 96 Tuesday, February 26, 2013 11:33 AM