Dell PowerEdge C1100 - Manual (Page 76)

76 Installing System Components
Figure 3-14. Removing and Installing the Integrated Storage Controller Card
Installing the Integrated Storage Controller Card
1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Open the system. See "Opening the System" on page 55.
3 Place the three spacer pins on the system board. See Figure 3-14.
4 Install the integrated storage controller card in place. See Figure 3-14.
5 Connect the SAS data cable to the integrated storage controller card.
6 Close the system. See "Closing the System" on page 56.
7 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
1 spacer pins (3) 2 integrated storage controller card
3 SAS cables connector
3 2
1
book.book Page 76 Tuesday, February 26, 2013 11:33 AM