Installing the control panel assembly – Dell PowerEdge C1100 User Manual
Page 93
Installing System Components
93
4 Slide the cover away toward the back of the system to remove it.
5 Disconnect the USB and LED signal cables and remove the two securing
screws.
6 Slide the front LED Board toward the front of the system to remove it.
Figure 3-25. Removing the Control Panel Assembly
Installing the Control Panel Assembly
1 Slide the front LED Board toward the front of the system and secure in
place with the eight screw on the front and sides of the system cover.
2 Connect the USB and LED signal cables and secure in place with
the two screws.
3 Replace the cooling shroud. See "Installing the Cooling Shroud" on
4 Replace the system cover. See "Closing the System" on page 56.
5 Reconnect the system and peripherals to their electrical outlets,
and turn on the system.
1
screws (2)
2
USB cable
3
LED signal cable
4
front LED board
4
3
1
2
book.book Page 93 Tuesday, February 26, 2013 11:33 AM