Port assignments, User’s guide – Dell Managed PDU LED User Manual

Page 202

Advertising
background image

USER’S GUIDE

Ma

na

ge

d R

a

ck

PD

U

197

Change default user names and passwords immediately

After installation and initial configuration of the Rack PDU, immediately change the
user names and passwords from their defaults to unique user names and passwords to
establish basic security.

Port assignments

If Telnet, the FTP server, SSH/SCP, or the Web server uses a non-standard port, a user
must specify the port in the command line or Web address used to access the Rack
PDU. A non-standard port number provides an additional level of security. The ports
are initially set at the standard “well known ports” for the protocols. To increase security,
reset the ports to any unused port numbers from 5001 to 32768 for the FTP server and
from 5000 to 32768 for the other protocols and servers. (The FTP server uses both the
specified port and the port one number lower than the specified port.)

User names, passwords, and community names with SNMPv1

All user names, passwords, and community names for SNMPv1 are transferred over
the network as plain text. A user who is capable of monitoring the network traffic can
determine the user names and passwords required to log on to the accounts of the
command line interface or Web interface of the Rack PDU. If your network requires the
higher security of the encryption-based options available for the command line
interface and Web interface, disable SNMPv1 access or set its access to

Read

. (

Read

access allows you to receive status information and use SNMPv1 traps.)

To disable SNMPv1 access, on the

Administration

tab, select

Network

on the top

menu bar and

access

under the

SNMPv1

heading on the left navigation menu. Clear

the

Enable SNMPv1 access

checkbox and click

Apply

.

To set SNMPv1 access to

Read

, on the

Administration

tab, select

Network

on the top

menu bar and

access

control

under the

SNMPv1

heading on the left navigation menu.

Then, for each configured Network Management System (NMS), click the community
names and set the access type to

Read

.

Advertising