Dell 3333/3335dn Mono Laser Printer - Manual (Page 161)

Custom Scan Sizes menu
Menu item Description
Custom Scan Size <x>
Scan Size Name
Width
3–14.17 inches (76–360 mm)
Height
3–14.17 inches (76–360 mm)
Orientation
Landscape
Portrait
2 scans per side
Off
On
Specifies a custom scan size name and options. This name replaces a Custom
Scan Size <x>
name in the printer menus.
Notes:
• 8.5 Inches is the US factory default setting for Width. 216 millimeters is
the international factory default setting for Width.
• 14 Inches is the US factory default setting for Height. 356 millimeters is
the international factory default setting for Height.
• Landscape is the factory default setting for Orientation.
• Off is the factory default setting for 2 scans per side.
• User Default is the factory default setting for ADF Pick Roller Force.
Universal Setup menu
These menu items are used to specify the height, width, and feed direction of the Universal Paper Size. The Universal
Paper Size is a user
‑defined paper size setting. It is listed with the other paper size settings and includes similar options,
such as support for duplex printing and printing multiple pages on one sheet.
Menu item Description
Units of Measure
Inches
Millimeters
Identifies the units of measure
Notes:
• Inches is the US factory default setting.
• Millimeters is the international factory default setting.
Portrait Width
3–14 inches
76–360 mm
Sets the portrait width
Notes:
• If the width exceeds the maximum, the printer uses the maximum
width allowed.
• 8.5 inches is the US factory default setting. Inches can be increased
in 0.01
‑inch increments.
• 216 mm is the international factory default setting. Millimeters can
be increased in 1
‑mm increments.
Portrait Height
3–14 inches
76–360 mm
Sets the portrait height
Notes:
• If the height exceeds the maximum, the printer uses the maximum
height allowed.
• 14 inches is the US factory default setting. Inches can be increased in
0.01
‑inch increments.
• 356 mm is the international factory default setting. Millimeters can
be increased in 1
‑mm increments.
Understanding printer menus 161