Dell 3333/3335dn Mono Laser Printer - Manual (Page 175)

Menu item Description
Parity
Even
Odd
None
Ignore
Sets the parity for serial input and output data frames
Note: None is the factory default setting.
Honor DSR
On
Off
Determines whether the printer uses the DSR Signal. DSR is a handshaking signal used
by most serial cables.
Notes:
• Off is the factory default setting.
• The serial port uses DSR to distinguish data sent by the computer from data
created by electrical noise in the serial cable. The electrical noise can cause
stray characters to print. Select On to prevent stray characters from printing.
• This menu item appears only if Serial RS
‑232/RS‑422 is set to RS 232.
SMTP Setup menu
Use the following menu to configure the SMTP server.
Menu item Description
Primary SMTP Gateway
Primary SMTP Gateway Port
Secondary SMTP Gateway
Secondary SMTP Gateway Port
Specifies SMTP server port information
Note: 25 is the default SMTP gateway port. Range is 1
‑65536.
SMTP Timeout
5–30
Specifies the amount of time in seconds before the server stops trying to
send the e
‑mail
Note: 30 seconds is the factory default setting.
Reply Address Specifies a reply address of up to 128 characters in e-mail sent by the
printer
Use SSL
Disabled
Negotiate
Required
Sets the printer to use SSL for increased security when connecting to the
SMTP server
Notes:
• Disabled is the factory default setting for Use SSL.
• When the Negotiate setting is used, your SMTP server determines if
SSL will be used.
SMTP Server Authentication
No authentication required
Login/Plain
CRAM
‑MD5
Digest
‑MD5
NTLM
Kerberos 5
Specifies the type of user authentication required
Note: “No authentication required” is the factory default setting.
Understanding printer menus 175