Dell Precision 330 User Manual

Page 161

Advertising
background image

Solving Problems

161

Sector not found

The operating system is unable to

locate a sector on the diskette or hard

drive.

See "

Diskette Drive Problems

" and "

Hard

Drive Problems

."

Seek error

The operating system is unable to

find a specific track on the diskette or

hard drive.

If the error is on the diskette drive, try a

different diskette in the drive.

Shutdown failure

A chip on the system board might be

malfunctioning.

Run the System Board Devices tests in the

Dell Diagnostics

.

Time-of-day clock stopped

The battery may be dead.

Enter

system setup

and correct the date or

time.
If the problem persists, see "

Battery

Problems

."

Time-of-day not set

The time or date displayed in the

system configuration information

does not match the system clock.

Enter

system setup

and correct the date or

time.

Timer chip counter 2

failed

A chip on the system board might be

malfunctioning.

Run the System Board Devices tests in

the

Dell Diagnostics

.

Unexpected interrupt in

protected mode

The keyboard controller might be

malfunctioning, or one or more

RIMMs may be loose.

Run the System Memory and the

Keyboard tests in the

Dell Diagnostics

.

WARNING: Dell’s Disk

Monitoring System has

detected that drive [0/1]

on the [primary/secondary]

EIDE controller is

operating outside of

normal specifications. It

is advisable to

immediately back up your

data and replace your hard

drive by calling your

support desk or Dell

Computer Corporation.

Power-on self-test (POST) has

queried the EIDE drive for status

information. The drive has returned a

parameter from the call that indicates

it has detected possible error

conditions for its operating

specifications.

When your computer finishes booting,

immediately back up your data and

replace your hard drive. Restore the data

to the replaced drive.
Back up the data on your hard drive. If a

replacement drive is not immediately

available and the drive is not the only

bootable drive, enter

system setup

and

change the appropriate drive setting to

None. Remove the drive from the system.

Write fault

Write fault on selected

drive

The operating system cannot write to

the diskette or hard drive.

See "

Diskette Drive Problems

" and "

Hard

Drive Problems

."

S y s t e m M e s s a g e s

( c o n t i n u e d )

Message

Cause

Action

Advertising