Dell Precision 330 User Manual
Page 77
Installing Upgrades
77
To further ensure proper positioning of the drive in the chassis, insert
and tighten all four screws in the order in which the holes are numbered
(the holes are marked "1" through "4").
6
Slide the new drive/bracket assembly into the drive bay until both
drive bracket tabs snap securely into place (see the following figure).
I n s t a l l i n g t h e D r i v e B r a c k e t ( D e s k t o p C h a s s i s )
7
Connect the interface cable for the drive. See "
NOTICE:
To avoid possible damage, you must match the colored strip on the
interface cable with pin 1 on both the drive and system board connectors.
a
If you are installing an EIDE device, ensure that the interface
cable is properly connected to the EIDE connector on the system
drive/bracket assembly
bracket tabs (2)