Dell PowerEdge C6100 - Manual (Page 26)

26 Using the Baseboard Management Controller
ww
w
.
de
l
l
. co
m
|
s
u
pp
o
rt
. d
e
ll
. c
o
m
Table 1-26. Firmware Commands (NETFUN: 08H, 09H)
Commands NetFn CMD Request and Response
Update Firmware Firmware 01H REQUEST
Byte 1
Interface Used—Interface the image is transmitted through:
00H: System interface, e.g., KCS
01H: Networking, e.g., TFTP, FTP, or HTTP
02H: USB MSC
Byte 2
Update Type:
[7]: Force update.
0H: Normal update. An update operation occurs only when
the BMC validates the target board, target product, and
version number.
[6.0]: Reserved
Byte 3:14
Install Options:
This field is optional. If present, it contains the list of options
that control the installation procedure. The number
definitions are specific to the vendor.
RESPONSE
Byte 1 — Completion code
Byte 2 — Task ID