Dell PowerEdge C6100 - Manual (Page 32)

32 Using the Baseboard Management Controller
Table 1-32. Dell OEM Commands (NETFUN: 30H, 31H)
Commands NetFn CMD Request and Response
Restore to defaults OEM 04 REQUEST:
Byte 1 -Configuration to be restored to
defaults:
[7:5] 111b= Restore the remaining
parameters not included in below lists.
000b= Remaining parameters stay what it
is.
All other values are reserved
[4] 1b= Restore PEFs to defaults
[3] 1b= Restore serial configuration
parameters to defaults
[2] 1b= Restore SOL configuration
parameters to defaults
[1] 1b= Restore LAN configuration
parameters to defaults
[0] 1b= Restore user accounts to defaults
RESPONSE:
Byte 1 –Completion Code
CCh = restore to one or more of the
configuration not supported.
Byte 2 – Task ID.
Use the Task ID to get the restore status. The
Task ID is automatically become invalid after
120 seconds when the restore requesting is
completed. 00h reserved.
Get Restore Status OEM 05 REQUEST:
Byte 1 – Task ID
Task ID, the value returned by previous call
to Restore to
Defaults command.
RESPONSE:
Byte 1 –Completion Code
Byte 2 –Default Restore Status:
00h: Restore in progress
01h: Restore completed