Dell PowerEdge C6100 - Manual (Page 35)

35 Using the Baseboard Management Controller
Table 1-36. Vendor OEM Commands (NETFUN: 34H, 35H)
Commands NetFn CMD Request and Response
SetFanControl OEM 61H REQUEST:
Byte 1 – Fan Control Setting
[7] - Enableed/Disabled FAN Control
0: Disabled(Default)
1: Enabled
[6:0] - Duty Cycle Setting. The rage is from 0
to 100, others are reserved.
RESPONSE:
Byte 1 — Completion code
GetFanControl OEM 62H REQUEST:
(None)
RESPONSE:
Byte 1 — Completion code
Byte 1 – Fan Control Setting
[7] - Enableed/Disabled FAN Control
0: Disabled(Default)
1: Enabled
[6:0] - Duty Cycle Setting. The rage is from 0
to 100, others are reserved.