Installing the system board, Hooks on the chassis. see figure 3-33 – Dell PowerEdge 2900 User Manual
Page 109
Installing System Components
109
Figure 3-33.
Removing the System Board
Installing the System Board
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. See your Product Information Guide for complete information about safety
precautions, working inside the computer, and protecting against electrostatic discharge.
1 Unpack the new system board.
2 Install the system board.
a
Hold the system board by its front edge and the memory module socket ejectors.
b
Carefully lower the system board into the chassis with the DIMM-socket side of the board tilted
down slightly to allow room for the board to clear the chassis wall slides. Ensure that the I/O
connectors on the back edge of the board fit underneath the ledge on the inside of the chassis
back panel.
When the board is properly positioned, the tabs on the chassis will fit through the corresponding
slots in the system board.
c
Slide the system board tray toward the back of the chassis until the retention pin snaps into
place.
1
retention pin
2
system board
3
chassis hooks
1
2
3