Dell PowerEdge 2900 - Manual (Page 23)

About Your System
23
E1A14 SAS Cable A SAS cable A is unseated, missing,
or bad. Check the cable connection to
the SAS backplane. See "Cabling
the SAS Backplane Boards" on
page 99.
E1A15 SAS Cable B SAS cable B is unseated, missing,
or bad. Check the cable connection to
the SAS backplane. See "Cabling
the SAS Backplane Boards" on
page 99.
E1A16 SAS Cable FB Flex bay SAS cable is unseated,
missing, or bad. Check the cable connection to
the SAS backplane. See "Cabling
the SAS Backplane Boards" on
page 99.
E1A17 Pwr Cable FB Flex bay power cable is unseated,
missing, or bad. Check the power cable
connection to the flex bay
backplane. See "Installing the 1x2
Flex Bay Drive Bracket" on
page 95.
E1A18 PDB Ctrl Cable The power distribution board
control cable is unseated,
missing, or bad. Ensure that the power
distribution board control cable is
seated properly. If the problem
persists, replace the power
distribution board control cable.
See "Installing the Power
Distribution Board" on page 112.
E2010 No Memory No memory is installed in the
system. Install memory. See "Memory" on
page 82.
E2011 Mem Config Err Memory detected, but is not
configurable. Error detected
during memory configuration. See "Troubleshooting System
Memory" on page 124.
E2012 Unusable Memory Memory is configured, but not
usable. Memory subsystem
failure. See "Troubleshooting System
Memory" on page 124.
E2013 Shadow BIOS Fail The system BIOS failed to copy
its flash image into memory. See "Troubleshooting System
Memory" on page 124.
E2014 CMOS Fail CMOS failure. CMOS RAM not
functioning properly. See "Getting Help" on page 147.
E2015 DMA Controller DMA controller failure. See "Getting Help" on page 147.
E2016 Int Controller Interrupt controller failure. See "Getting Help" on page 147.
Table 1-6. LCD Status Messages (continued)
Code Text Causes Corrective Actions