Dell PowerEdge 2900 - Manual (Page 65)

Installing System Components
65
Figure 3-11. Cooling Fans
Removing and Installing a Fan
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. See your Product Information Guide for complete information about safety
precautions, working inside the computer, and protecting against electrostatic discharge.
1 Open the system. See "Opening the System" on page 53.
2 Squeeze the release latches on top of the fan and lift the fan out of the fan bracket. See Figure 3-12.
NOTICE:
Do not remove more than one fan at a time and do not operate the system with any fan removed for an
extended period of time. Overheating can occur, resulting in a system shutdown and loss of data.
3 To replace the fan, align the connector on the fan with the fan connector on the system board and
insert the fan into the fan bracket.
The fan will start when it seats into the connector.
4 Close the system. See "Closing the System" on page 53.
1 expansion-card fan (FAN1) 2 processor fan (FAN2) 3 processor fan (FAN3)
4 memory module fan (FAN4) 5 memory module fan (FAN5) 6 memory module fan (FAN6)
3
1
2
4
5
6