Dell PowerEdge 2900 - Manual (Page 29)

About Your System
29
FBD training error: The
following branch has been
disabled: Branch x
The specified branch (channel pair)
contains DIMMs that are
incompatible with each other. Ensure that only Dell-qualified memory
is used. Dell recommends purchasing
memory upgrade kits directly from
www.dell.com or your Dell sales agent to
ensure compatibility.
Gate A20 failure Faulty keyboard controller; faulty
system board. See "Getting Help" on page 147.
General failure The operating system is unable to
carry out the command. This message is usually followed by
specific information. Note the
information and take the appropriate
action to resolve the problem.
Invalid NVRAM
configuration, Resource
Re-allocated
System detected and corrected a
resource conflict. No action is required.
Keyboard Controller
failure
Faulty keyboard controller; faulty
system board See "Getting Help" on page 147.
Manufacturing mode
detected
System is in manufacturing mode. Reboot to take the system out of
manufacturing mode.
MEMBIST failure - The
following DIMM/rank has
been disabled by BIOS:
DIMM x Rank y
Faulty memory module(s). See "Troubleshooting System Memory"
on page 124.
Memory address line
failure at address , read
value expecting value
Faulty or improperly installed memory
modules. See "Troubleshooting System Memory"
on page 124.
Memory double word logic
failure at address , read
value expecting value
Memory odd/even logic
failure at address, read
value expecting value
Memory write/read failure
at address , read value
expecting value
Memory tests terminated by
keystroke.
POST memory test terminated by
pressing the spacebar. Information only.
Table 1-7. System Messages (continued)
Message Causes Corrective Actions