Dell PowerEdge 2900 - Manual (Page 111)

Installing System Components
111
CAUTION:
Whenever you need to lift the system, get others to assist you. To avoid injury, do not attempt to lift the
system by yourself.
1 Turn off power to the system and disconnect the power cable from the power source.
2 Detach all cables from the rear of the system.
3 If the system is a tower system, place it on its side on top of a work surface.
4 Open the system. See "Opening the System" on page 53.
5 Perform all of the additional steps to remove the system board in "Removing the System Board" on
page 107.
6 Disconnect all cables connecting the system board to the SAS backplane board, the control panel, and
any tape or hard drives in the peripheral or flex bays.
7 Disconnect the cables connecting the system board and SAS backplane board to the power
distribution board.
8 Unlock the power supplies from the system and slide them back 5 cm (2 inches). See "Removing a
Power Supply" on page 62
9 Using a #2 Phillips screwdriver, remove the five screws from the power distribution board. See
Figure 3-34.
10 Remove the power distribution board from the system chassis. See Figure 3-34.