Dell 2355dn Multifunction Mono Laser Printer - Manual (Page 151)

150
Your original document is divided into 9 portions. Each portion is scanned and printed one
by one in the following order:
ID Copying
When you copy using this feature, the printer prints one side on the upper half of the paper and the
other side on the lower half without reducing the original. This feature is helpful for copying a
small-sized document, such as a name card.
If the original document is larger than the printable area, some portions may not be printed.
This special copy mode can be applied when you load a document using only the document glass.
If a document is detected in the DADF, the ID copying feature does not work.
NOTE: You cannot adjust the copy size using the Zoom menu for ID copying.
To make the ID copying:
1 Press ID Copy ( ) in the operator panel.
OR
Press Copy ID Copy from the home screen.
2 Place the front side of an original facing down on the document glass where arrows indicate
as shown, and close the scanner lid.
3 Press the Next ( ) button.
4 If necessary, customize the copy settings including number of copies, contrast, original type,
and original size by pressing Options. See "Setting Copy Options".
5 Press Start ( ) . (on the touch screen or the operator panel)
6 Turn the original over and place it on the document glass, where arrows indicate as shown
then, close the scanner lid.
7 Press Start ( ) . (on the touch screen or the operator panel)
NOTE: You can cancel the copy job at any time. Press , and the copying will stop.