Dell 2355dn Multifunction Mono Laser Printer - Manual (Page 203)

202
Receive Mode You can select the default fax receiving mode.
• Fax mode (automatic receive mode): The printer answers an incoming call
and automatically goes into receive mode. The number of rings before the
printer answers can be set in the Ring to Answer option. If the user memory is
full, the printer can no longer receive any incoming fax. Secure free memory to
resume by canceling Priority Send or printing received faxes.
• Tel mode (manual receive mode): Receives a fax by pressing On Hook Dial
and then Start.
• Ans/Fax mode: The printer can share one telephone line with an answering
machine. In this mode, the printer may monitor the fax signal and pick up the
line if there are fax tones. If the phone communication in your country is serial,
this mode is not available.
• DRPD mode: Before using the Distinctive Ring Pattern Detection (DRPD)
option, distinctive ring service must be installed on your telephone line by the
telephone company. After the telephone company has provided a separate
number for faxing with a distinctive ring pattern, configure the fax setup to
monitor for that specific ring pattern.
Redial Delay Your printer can automatically redial a remote fax machine if it was busy.
Intervals from 1-15 minutes can be entered.
Redial Attempt You can specify the number of redial attempts, 0-13.
MSG Confirm You can set your printer to print a report showing whether the transmission was
successful, how many pages were sent, and more. The available options are On,
Off and On-Error, which prints only when a transmission is not successful.
Auto Report A report with detailed information about the previous 50 communications
operations, including time and dates. The available options are On or Off.
Auto Reduction When receiving a document as long as or longer than the paper loaded in the
paper tray, the printer can reduce the size of the document to fit the size of paper
loaded in the printer. Select On if you want to automatically reduce the
incoming document.
With this feature set to Off, the printer cannot reduce the document to fit onto
one page. The document is divided and printed in actual size on two or more
pages.
Discard Size When receiving a document as long as or longer than the paper installed in your
printer, you can set the printer to discard any excess at the bottom of the page. If
the received page is outside the margin you set, it will print on two sheets of
paper at the actual size.
When the document is within the margin and the Auto Reduction feature is
turned on, the printer reduces the document to fit it onto the appropriate sized
paper and discarding does not occur. If the Auto Reduction feature is turned off
or fails, the data within the margin will be discarded. Settings range from 0-30
mm.
Option Description