Dell 2355dn Multifunction Mono Laser Printer - Manual (Page 316)

315
Global address problems
Common Windows Problems
Condition Suggested solutions
LDAP Maximum Query
Exceeded... There exists limitation for number of results from the LDAP server for each LDAP query.
The range for the number of results is 0~100.
Set the query between 1 and 100.
LDAP Server Authentication
Failed... If a device has invalid credential (ID or PW), LDAP server will return authentication
failure message.
LDAP Query Failed... If a user presses the STOP key during the search and no data was returned before
cancelling, the device will display this message.
LDAP No Such Attribute... Result is depending on the query from the device.
If a user sees this error message, changing the query can avoid this situation.
LDAP Address Not Found... This case is happening only when connection was successful and search result was
nothing.
LDAP Server Not Found... It could be a wrong IP address setup or Server is not working correctly.
Administrator can suspect the physical condition, device (client) configuration and server
status.
In case of device configuration, administrator should check IP address or hostname or
port number.
LDAP Time Limit Exceeded... It only happens when server is returning error code=8 which means "Server Time-out".
When server couldn't return all search result within the timeout.
This is abnormal case which is depending on the server side condition though.
A user can test server operation with other queries.
Condition Suggested solutions
“File in Use” message appears
during installation. Exit all software applications. Remove all software from the StartUp Group, then restart
Windows. Reinstall the printer driver.
“General Protection Fault”,
“Exception OE”, “Spool32”, or
“Illegal Operation” messages
appear. Close all other applications, reboot Windows and try printing again.