Dell PowerVault NX3500 - Manual (Page 80)

80 Installing System Components
Figure 2-16. Replacing the System Battery
3 Locate the battery socket. See Figure 5-1.
CAUTION: To avoid damage to the battery connector, you must firmly support the
connector while installing or removing a battery.
4 To remove the battery, push the metal tab away from the battery until the
battery pops out. See Figure 2-16.
5 To install the new system battery, hold the battery with the “+” facing up,
and aligned to the metal tab on the socket.
6 Press the battery straight down into the socket until it snaps into place.
7 Close the system. See "Closing the System" on page 53.
8 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
9 Enter the System Setup program to confirm that the battery is operating
properly.
10 Enter the correct time and date in the System Setup program's Time and
Date fields.
11 Exit the System Setup program.
1 positive side of battery connector 2 negative side of battery connector
3 system battery
1
2
3
book.book Page 80 Monday, January 24, 2011 12:24 PM