HP 48g Graphing Calculator - Manual (Page 372)

I
PORT:
I
DEJECT;
_DEL-SPflCE BELOV: 1.0 ¿LINEF
I PRINT j
CHPDSE PRINT PDRT
—EglRi^—■ ! itaaiita
The Infrared PRINT Screen
4 .
Press
C H O O S ,
move the highlight to a variable you wish to print
and press OK
5. Optional: Adjust any of the printing parameters that you wish,
DBL-SPflCE Put a check-mark to produce double-spaced output.
DELAYS Enter the number of seconds (cannot be more
than 6.9) the HP 48 waits between sending lines
of information to an infrared printer. To optimize
printing efficiency, set the delay just longer than
the time the printhead requires to print one line of
information (default is 1.8 seconds).
LIHEF Normally (check-mark on), each print command
completes data transmission by automatically
executing the CR [carnage right) command, which
27 tells the printer to print the data currently in its
buffer and leave the print head at the right end
of the print line. Alternatively (check-mark off ),
you can suppress the automatic CR command
and accumulate several print commands in the
print buffer, which are then printed only when you
manually execute CR OQZ3PRIWT
C R : ) .
6. Press PR.I NT,
To print 3 I'anairie via fie Serial Interface cai3le:
1. Be sure that the printer is set up properly and that the cable is
properly connected.
2. Press (▼ }(¥) (f) 0 to open the F'RIHT form.
27-4 Transmitting and Printing Data