Й:|дшш1тта, Hp 48 set the i/o parameters, Select the communications port (usually – HP 48g Graphing Calculator User Manual
Page 376: For transfers between the hp 48 and a computer)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2. Keep the HP logo on the 4-pin connector facing up, then plug the
cable into the HP 48. You should feel it lightly snap into place.
,Not quite flush
27
1. Make sure that the serial cable is properly connected to the
computer and to the HP 48.
2. HP 48. Press
1 fiir) |X) OK to view the TRRHSFER form.
TRANSFERi
PORT:
Hire
TYPE:
Kermit
NAME:
— — 1 | Д 1
FMT:
flSC
KLAT:
Newl
CHK:
3
6AUI}:9600 PARITY: None _BMRH
ENTER NAMES ПР VARS TD TRANSFER
й:|дшШ1тта—
The Wire TRANSFER Screen
3. HP 48 Set the I/O parameters:
P O R T “
Select the communications port (usually
w ir e
for
transfers between the HP 48 and a computer).
T Y P E :
Select the transfer protocol, either Kerfiit or
X Mo
d e n .
FMT;
Select the transfer format, either ASCII or Binary
(only available for Kermit),
27-8 Transmitting and Printing Data