Canon 814XL-S - Manual (Page 94)

1. To film in the single frame mode, set the
filming mode dial at the Q] position and push
the shutter release button each time you want
to expose a frame.
2. For timed interval filming, set the filming
mode dial at the 1, 5, 20, or 60 second interval
position as needed. Shift the R/RL switch to
RL and push the shutter release lever. A single
frame is immediately exposed, and the camera
begins the timed exposure of single frames at
the pre-selected rate.
* The film end warning wili not appear in the
viewfinder if the film ends tluring single­
frame or timed interval filming.
The foiiowing functions are inoperable during
singie-frame and timed intervai fiiming:
1. Lap dissolve (1014XL-S only)
2. Fade-in or fade-out using the fade lever
3. Instant slow motion
4. Filming speed control
DETERMINING TIMED INTERVAL
After deciding the projection time and filming
speed, use the following formula to determine
the filming mode dial interval setting prior to
filming;
Interval Time^ __^Filmi^ Time (seconds!
(seconds) “ Projection Time x Filming Speed
(seconds) (frames/second)