AVer CM5000 User Manual
Page 143
136
9. In System section, mark the check box to set the conditions that are caused by system.
-
Reboot: when the NVR system reboot without abnormal condition, the system will
send out the alarm message.
-
Abnormal Reboot: when the NVR system reboot in irregular condition, the system will
send out the alarm message.
-
Hard Disk failed: when the hard disk doesn
’t work normally, the system will send out
the alarm message.
10. After setting all alarm conditions, click Apply to save the settings.
11. Next, user needs to set the alarm action when alarm has triggered. Please refer to chapter
of Setup the Alarm Action.
12. To modify the alarm condition setting, click Setting button of Alarm # that user has created.
Remember to click Apply to save the changes after modification.
13. To delete the alarm #, select the alarm # that user wants to delete and click Delete button.