AVer CM5000 - Manual (Page 154)

147
6.2.8 I/O Setting
Setup I/O device status.
Sensor Setting
1. Click Setup tab > Alarm Setting > Sensor tab.
2. Click the drop-down list and select the Sensor #.
3. Enter sensor name in Name column.
4. The system automatically detects the card and input number. In the Content section, user
can enter a short description of sensor in Description column.
5. In the test section, click Test to check the sensor status. Red is high and Green is low.
6. Click Apply to save the setting. To exit without saving the setting, click Cancel button.