Dynojet 424xLC2: Installation Guide - Manual (Page 118)

C H A P T E R 4
Load Cell Calibration
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
4-22
9 Install the calibration arm and weights using the bolts at the end of the calibration
arm.
Note: If you do not have enough room to use the bolt pattern closest to the end of
the calibration arm, use the bolt pattern in the center of the arm. Refer to Figure
4-24 on page 4-23.
9a
Secure the calibration arm to the eddy current brake by tightening the bolt
using the handle.
9b Gently place the weights on the calibration arm.
Note: Verify the calibration arm is not contacting the cover.
The calibration weights are very heavy. The weights must be set on the
arm gently or you could damage the load cell.
Figure 4-23: Install the Calibration Arm and Weights Using the Bolt Pattern Closest to the End
TM071
weights
weight support pin
secure arm to brake by
tightening handle