Dynojet 424xLC2: Installation Guide User Manual
Page 119
Advertising
4-23
E D D Y C U R R E N T B R A K E I N S T A L L A T I O N
Load Cell Calibration
Version 1
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
If you do not have enough room to use the bolt pattern closest to the end of the
calibration arm, use the bolt pattern in the center of the arm as shown in
Figure 4-24.
10 With the calibration arm and weights secured, click Next in the Load Cell
Calibration dialog to continue.
Figure 4-24: Install the Calibration Arm and Weights Using the Bolt Pattern in the Center
T 072
M
weights
weight support pin
secure arm to brake by
tightening handle
Advertising
This manual is related to the following products: