Dynojet 424xLC2: Installation Guide - Manual (Page 60)

C H A P T E R 3
Cable Routing
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
3-18
11 Connect the IR temperature sensor cable (L) to the eddy current brake driver.
12 Connect the load cell cable (M) to the eddy current brake driver.
13 Connect the controller cable (E) from the eddy current brake to the eddy current
brake driver.
14 Connect the CAN pendant cable (F) to the DynoWare RT module.
15 Connect the primary/secondary pickup cable (H) to the DynoWare RT module.
16 Connect the remote atmos cable (D) to the DynoWare RT module.
17 Connect the ethernet cable (C) to your DynoWare RT module and connect to your
network. Refer to “Network Connections” on page 1-15 for more information.
18 Connect the power cable (A) to the DynoWare RT module. Plug the power cable
into your power source.