Dynojet 424xLC2: Installation Guide - Manual (Page 131)

6-5
B A S I C D Y N O O P E R A T I O N
Loading the Vehicle
Version 1 Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
10 Tighten the tie-down straps evenly making sure that the drive wheels remain
centered on the drum.
The tie-down straps should always be connected to the vehicle’s solid axle
or the suspension control arms. Factory tie-down hooks connected to the
vehicle’s frame may be used on the end opposite the drive wheels (for
example: the front end of a rear driven vehicle).
11 Release the brake on the vehicle and the dyno.
12 Start the vehicle and put the transmission into first gear or drive.
13 Press the accelerator pedal so the drums begin turning slowly. While the drums
are slowly turning, verify the stability of the vehicle.
14 Check all the straps and ensure the vehicle is tracking straight on the dyno.