Dynojet 424xLC2: Installation Guide User Manual
Page 141
Advertising
6-15
B A S I C D Y N O O P E R A T I O N
Preventative Maintenance
Version 1
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
5
If the brake shoe clearance is out of specification, loosen the upper nut on the
bottom of the air can rod.
6
Adjust the lower nut until the brake shoes are .25 inch (6mm) away from the dyno
drum.
7
Tighten the upper nut on the air can rod down onto the brake actuating tube to
sandwich the tube between the two nuts.
8
Torque the lower nut to 110 foot-pounds.
If you cannot adjust the brakes to specification, you will need new brake shoes.
Contact Dynojet.
Figure 6-8: Adjust the Brake Shoe Clearance
BR032
lower nut
air can rod
upper nut
brake actuating tube
Advertising
This manual is related to the following products: