Dynojet 424xLC2: Installation Guide User Manual
Page 53
Advertising
3-11
4 W D D Y N O I N S T A L L A T I O N
Dyno Installation
Version 1
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
5
Secure the rail clamps to the cradle assembly on the dyno using two 3/8-inch
shoulder bolts and two spacers each.
6
Replace the pins and cotter pins removed earlier from the four cradle assemblies
as shown in Figure 3-5.
7
Move the rail clamps up and down and verify they move freely.
8
Roll the dyno back and forth and verify the rail clamps are not binding and the
track assembly is square.
Note: For clarity, the stationary dyno is not shown.
Figure 3-6: Secure the Dyno to the Rail Clamps
AD353
spacer
bolt
Advertising
This manual is related to the following products: