Dynojet 424xLC2: Installation Guide - Manual (Page 144)

A P P E N D I X A
Installation
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
A-2
INSTALLATION
Use the table below to determine the catalog number, drill bit size, minimum hole
depth, and setting tool catalog number.
Use the following instructions to install the Red Head anchors.
1 Drill the hole in the concrete the same outside diameter as the anchor being used
to any depth exceeding minimum embedment.
Figure A-1: Red Head Anchor—Drill the Hole
2 Insert the anchor.
Figure A-2: Red Head Anchor—Insert the Anchor
catalog number drill bit size
minimum hole
depth setting tool
catalog number
Carbon Steel
RM-38/RL-38 (9.5
mm)
1/2-inch 1 5/8-inch (41.2 mm) RT-138
anchor