Dynojet 424xLC2: Installation Guide - Manual (Page 123)

5-3
S I D E D E C K A S S E M B L Y I N S T A L L A T I O N
Side Deck Installation
Version 1 Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
I NSTALLING THE S IDE D ECK A SSEMBLY
1 Lay the platform assembly on it’s side.
2 Secure the two front step leg assemblies to the platform using two 3/8-16 x 3-inch
hex bolts, four 3/8-inch flat washers, two 3/8-inch lock washers, and two 3/8-
inch nuts each.
3 Secure the two back leg assemblies to the platform using two 3/8-16 x 3-inch hex
bolts, four 3/8-inch flat washers, two 3/8-inch lock washers, and two 3/8-inch
nuts each.
Figure 5-1: Install the Front and Rear Leg Assemblies
AD074
front leg assembly
rear leg assembly
platform assembly