Steel-bar-reinf – Oldcastle BuildingEnvelope Reliance StormMax User Manual
Page 12
9
R E L I A N C E S T O R M M A X I N S T A L L A T I O N M A N U A L
FIGURE 1.6
1.6 a. Insert and attach RS-15 reinforcement steel into HW-500 jamb or mullion
(Steel Height = Mullion Height) Attach RS-15 steel to HW-200-01 anchor sleeve using FS-322
at head and sill. See Figures 1.6a & b
b. Prior to HW-183-01 shear block attachment insert HW-200-01 anchor sleeves at
HW-500 vertical mullion ends and match drill .191 dia. hole.
c. Attach HW-183-01 shear block to HW-500 vertical mullion with FS-9 fastener.
d. Install FG-5185 interior spacer gasket cut to 2" from ends and 2" gaps at horizontal to allow
for WW-352 zone plugs.
e. Install and seal HW-325 end caps to top and bottom of HW-500 vertical mullion screw boss
with (2) FS-320 #10 x 1/2" drive screw .
HW-200-01 Anchor Sleeve
(for design pressures above 70 psf)
HW-500 Intermediate Vertical Mullion
HW-183-01 Shear Block
Drill #25 - .1495" to drill a
pilot hole into steel
for (1) FS-322 Fastener
(Repeat at Sill)
(2) FS-320 Drive Screw
HW-338 for Jambs and HW-325 for Mullions
Seal and tool sealant on end caps
RS-15 Reinforcement Steel
1-1/4"
CL
Slide HW-200-01 Anchor Sleeve with
attached RS-15 Steel into the Mullion
and then attach
HW-183-01 Shear Block
(4) FS-9 Fasteners
ALTERNATIVE REINFORCEMENT STEEL BAR
FIGURE 1.6a
FIGURE 1.6b