SINGER 9980 QUANTUM STYLIST - Manual (Page 14)

14
REMOVABLE EXTENSION
TABLE
A. REMOVING THE EXTENSION TABLE
Hook your finger under the left bottom side of
the removable extension table and slide it to the
left.
To attach, push the table to the right.
B. OPENING THE ACCESSORY CASE
Hook your finger under the left side of the
accessory drawer cover and pull toward you.
Note: Your machines accessories are stored
inside this drawer.
CHANGING THE PRESSER
FOOT
The presser foot must be changed according to
the stitch you sew, or work you do.
A. CHANGING THE PRESSER FOOT
1. Turn the hand wheel toward you until the
needle is at its highest point.
2. Raise the presser foot lifter.
3. Remove the presser foot by pushing the
presser foot release lever toward you.
4. Place desired foot with its pin directly under the
slot in presser foot holder.
5. Lower the presser foot lifting lever and the
presser foot will snap into place.
CAUTION: To prevent accidents.
Turn off the power switch before you change
the presser foot.
B. REMOVING THE PRESSER FOOT
HOLDER
When attaching presser feet that have their own
shank, or when cleaning the machine, you should
remove the presser foot holder.
1. Remove the presser foot.
2. Loosen the presser foot thumb screw and
remove the presser foot holder.
3. To replace the holder, pull up the holder as far
as it will go from bottom of presser bar.
4. Tighten the thumb screw.