Spo2 sensor connection, Setting up the printer, Sensor connection – Welch Allyn Vital Signs Monitor - User Manual User Manual
Page 26
20
Vital Signs Monitor
SpO
2
Sensor Connection
The Welch Allyn Vital Signs Monitor is available with a wide variety of SpO
2
sensors. The reusable
finger clip sensor is shipped with the Monitor. All other sensors may be ordered separately as
accessory items.
Attach the Nellcor SpO
2
sensor to the pulse oximetry extension cable. Then insert the connector
end of the extension cable into the SpO
2
connector port on the side of the Monitor as shown. The
SpO
2
connector port on the Monitor is clearly labeled “SpO
2
”. The extension cable can only be
inserted one way; matching the shape and pin configuration of the connector to the port. Push the
connector in until it is fully seated on the port.
NOTE:
Only Nellcor SpO
2
sensors and accessories may be used with this configuration of the
Welch Allyn Vital Signs Monitor.
Setting up the Printer
A fully integrated thermal printer is available as an option to the Welch Allyn Vital Signs Monitor.
To load paper into the printer follow these steps:
1. Grasp the printer cover as shown, and slide the cover off of the Monitor by sliding the cover
towards you.
Inserting the sensor connector into the
Monitor port.
Sliding off the printer cover