Welch Allyn Vital Signs Monitor - User Manual - Manual (Page 66)

60 Vital Signs Monitor
Wall Mount Kit (Model #5200-62 &
5200-63)
Refer to figure 2 for the following instructions)
1. Attach BASKET PLATE to wall by inserting
(5) #8 flat head screws (not provided)
through BASKET PLATE in four “D” holes
and one “B” hole. Securely tighten
screws.
NOTE: Mounting hardware should be
selected according to the wall
surface that monitor is being
attached to. Welch Allyn is NOT
responsible for the integrity of the
mounting means. If there is any
indecision or uncertainty on what
hardware to use, contact a
professional service for installation.
2. Assemble BASKET to BASKET PLATE by inserting (4) #8 x 3/16” long phillips screws through
basket holes marked “A” and into four threaded holes in BASKET PLATE. Securely tighten
screws.
3. For Model #5200-62 only, attach ACCESSORY PACK by orienting as shown in figure 2 and
inserting onto side plate of BASKET and pushing up. This will lock ACCESSORY PACK onto
BASKET.
I.V. Pole Kit (Model #5200-64 & 5200-65)
Refer to figure 2 for the following instructions)
1. Attach BASKET PLATE to I.V. BRACKET by inserting (4) #8 x 1/4” long flat head phillips screws
through four countersunk holes, designated “D”, into four threaded holes in bracket. Securely
tighten screws.
2. Assemble BASKET to BASKET PLATE by inserting (4) #8 x 3/16” long phillips screws through
basket holes marked “A” and into four threaded holes in BASKET PLATE. Securely tighten
screws.
3. For Model #5200-64 only, attach ACCESSORY PACK by orienting as shown in figure 2 and
inserting onto side plate of BASKET and pushing up. This will lock ACCESSORY PACK onto
BASKET.
Bedrail Kit (Model #5200-66 & 5200-67)
Refer to figure 3 for the following instructions)
1. Remove top two housing screws on one side of
MONITOR only.
2. Orient BEDRAIL as shown and attach using (2) #4 x 1 1/8”
long screws supplied. Securely tighten screws.
3. Repeat steps 1 & 2 on other side of MONITOR.
“B”
BASKET
PLATE
“D”
4X
“A”
4X
I.V.
BRACKET
BASKET
ACCESSORY
PACK
HARDWARE
INCLUDED
(4) #8 flat head screw, 1/
4” long
(4) #8 pan head screw, 3/
16” long Probe
Covers
FIGURE 2
Monitor
Bedrail