MK Diamond MK-101-24 - Manual (Page 22)

22
The Water Pump can be setup for operation in two ways, External Water Source or Re-circulation.
(B)
Place Water Pump in Water Pan.
Fill the Water Basin until water
completely covers the
Water Pump suction.
(A)
Remove the Drain Plug. Place
empty container under hole for
water drainage.
(B)
Place the Water Pump in an
external container and fill until
water completely covers the
Water Pump suction.
This is the preferred method of cooling.
NOTE: When using the re-circulation method, the water should be changed often for
longer pump life
(A)
Ensure the Drain Plug is
installed in the Water Basin.
CAUTION
Water Pump Setup for Operation
SETUP FOR OPERATION
External Water Source
Re-circulation
MK-101-24 SETUP
NOTE: If using a dry blade for operation, DO NOT connect the water pump.
1. Before powering or starting, check for damage that could prevent this
equipment from proper operation or performing it’s intended function.
Check for binding and proper alignment of moving parts. Check for dam-
aged, broken, or missing parts.
2. Verify the On/Off switch is in the OFF position.
3. Before connecting the MK-101-24 to a power supply, be sure the voltage,
cycle and phase of the job site power source meet these requirements.