MK Diamond MK-101-24 - Manual (Page 26)

26
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for
which it was designed.
(A)
Position the 45º Bullnose Miter
Guide and tighten the
retaining thumbscrew.
(B)
Position the tile on the 45º
Bullnose Miter Guide and the
Ruler/Stop. Turn the motor ON.
(C)
Verify proper cooling flow on
both sides of the blade (See
Maintenance Section to
increase/decrease flow).
(D)
Perform the cut. Turn the motor
OFF when work is complete.
CAUTION
45° Miter Cutting (Optional)
MK-101-24 OPERATION
To cut 45º Miters, the 45º Bullnose Miter Guide (MK Diamond Part No. 153201-MK)
should be used.
NOTE: