MK Diamond MK-101-24 User Manual
Page 36
Advertising
36
(J)
Push the motor toward the front
of the Cutting Head to loosen
the Micro-V Belt
(K)
Remove the Micro-V Belt
(L)
Install the new Micro-V Belt
(MK Diamond Part No. 158194)
(M)
Verify the Micro-V Belt is seated
in the grooves of both pulleys
(N)
Tighten the Motor Adjustment
Strap to remove slack
(O)
Check Micro-V Belt tension (proper
tension 1/8-inch) Repeat steps N and
O until proper Micro-V Belt tension is
achieved
(P)
Tighten the four motor mount-
ing bolts
(Q)
Install the Belt Guard
MK-101-24
MAINTENANCE
Advertising