MK Diamond MK-101-24 - Manual (Page 28)

28
The Cutting Head is heavy! Care must be used when changing the position
of the Cutting Head.
(A)
Ensure the ON/OFF Switch
is in the OFF position. Un-
plug the GFCI from the power
source.
(B)
Remove the Blade.
Remove Adjusting Knob.
(C)
Remove the Cutting Head from
the rear pivot hole.
(G)
Set cutting depth approximately
1/4 to 1/2 inch below the
surface of the Movable
Cutting Table.
CAUTION
For small tiles (6" tile or smaller) the Cutting Head
should be in the rear pivot hole and the Post should be
in the forward post retaining hole. For large tiles and
maximum cutting length, the Cutting Head should be in
the front pivot hole and the Post should be in the rear
post retaining hole.
Move Cutting Head Stop in upward position when using
rear pivot hole and in the down position when using front
pivot hole.
adjusting the Cutting Head
NOTE: For larger tiles and maximum cutting length, the cutting head should be in the front pivot hole.
NOTE:
NOTE:
MK-101-24 ADJUSTMENT
(B)
Remove the Blade.
Remove Adjusting Knob.
(C)
Remove the Cutting Head from
the rear pivot hole.
(D)
Install the Cutting Head onto
the front pivot hole.
(E)
Remove the Cutting Head Stop
Bolt. Rotate Cutting Head Stop
to down position and re-tighten
Cutting Head Stop Bolt.
(F)
Install the Adjusting Knob.