MK Diamond MK-101-24 - Manual (Page 29)

29
Hold the Post when removing the Post Support Plate.
The Cutting Head and Post are heavy! Use care when changing the position
of the Cutting Head.
(A)
Remove Water Basin and
Blade.
(B)
Remove the Cutting Head (See
Adjusting the Cutting Head.
(C)
Loosen the Post Support and
retaining bolts.
(D)
Remove the Post Support
and Retaining Bolts.
(E)
Remove and relocate the Post
to the rear Post retaining holes.
(F)
Install and tighten the Post
Support and retaining bolts.
(G)
Install the Cutting Head (See
Adjusting the Cutting Head)
(H)
Install the Water Basin and
Blade.
CAUTION
CAUTION
adjusting the Post for Maximum Cutting Length
MK-101-24 ADJUSTMENT