MK Diamond MK-101-24 - Manual (Page 35)

35
The MK-101-24 is designed with power transmission Micro-V Belt. In order to ensure the MK-101-24
operates a peak efficiency, the Micro-V Belt should be inspected monthly, and changed if the Micro-V
Belt shows damage and/or excessive wear.
Micro-V Belt Inspection, Adjustment and Replacement
When a new belt is installed, it should be inspected and re-tensioned after the first forty-
eight (48) hours of operation.
NOTE:
(A)
Remove the Diamond Blade
(B)
Remove the Cutting Head (See
Adjusting the Cutting Head)
(C)
Remove the two top Belt Guard
Bolts
(D)
Remove Belt Guard bottom bolt
(E)
Inspect the Micro-V Belt for cracks,
fraying, separation and wear. Go to
step H if replacement is required
(F)
Check belt for proper tension. If tension
correct, go to step Q (proper tension
should be 1/8-inch
deflection)
(G)
Loosen the two front motor
mounting bolts. If re-tensioning
only, go to step N
(H)
Loosen the two back motor
mounting bolts
(I)
Loosen the Motor Adjustment Strap
MK-101-24 MAINTENANCE