Night Optics Falcon 6x Gen 3 Gated Long-Range Night Vision Binocular - Manual (Page 35)

1-25/26 blank
Do not use excessive force to place the power
switch into the momentary IR position.
IR/PULL Position Power is drawn from the battery
compartment to energize the goggles
and IR light source and a steady red
indicator light in the left eyepiece.
It is critical that the goggles be turned off manually
before placing them in the flipped up position in
order to avoid detection by the enemy.
c. Automatic Shutoff. When some goggles are removed from
the headmount or helmet mount while in operation or flipped up in
the mount, they will not automatically cut off. They must be turned
off manually. To turn the goggles back on, turn the power switch
to RESET/OFF and then to ON again.
d. Highlight Cutoff. The goggles will automatically cut off after
70
± 30 seconds of operation in daylight or bright room light.
Individual bright lights (headlights, flashlights, or other
concentrated light sources) will not actuate the highlight detector
located on the front of the goggles. To turn the goggles back on,
turn the power switch to RESET/OFF position and then to ON
again.
CAUTION
WARNING