Para 2-5 – Night Optics Falcon 6x Gen 3 Gated Long-Range Night Vision Binocular User Manual
Page 69
2-34
Section III. Assembly and Preparation for Use
This chapter contains the information necessary to prepare the
goggles for operation. This includes unpacking (2-5), battery
installation (2-6), eyecups installation (2-7), demist shields
installation (2-8), sacrificial window installation (2-9), compass
installation (2-10) LIF installation (2-11), IR Spot/Flood lens
installation (2-12) headmount installation and adjustment (2-13),
headmount installation with protective mask (2-14), headmount
with helmet installation (2-15), original helmet mount to helmet
installation (2-16) new helmet mount to helmet installation (2-17)
new helmet mount with new nape strap to helmet installation (2-
18), AN/PVS-7D helmet mount to helmet installation (2-19) and 3X
magnifier installation (2-20).
The following steps must be accomplished prior to each mission
where the goggles are used.
Before releasing latches on the old shipping and
storage case, relieve air pressure inside shipping
and storage case by pressing relief valve button
located near the case handle.
(1)
Release the two latches securing top of shipping and
storage case and open.
(2)
Check contents for completeness (see Figure 1-1).
(3)
Remove carrying case. Open carrying case (Figure 1-
1), remove goggles, and check contents for completeness.
CAUTION