Night Optics Falcon 6x Gen 3 Gated Long-Range Night Vision Binocular User Manual
Page 46
2-
11
Not Fully
Mission
Capable If:
Power switch
has no definite
stopping points
or knob is bro-
ken or missing.
IR source does
not work, or it
works and the
red light does
not appear in
the left eyepiece.
If damaged,
refer to higher
level of
maintenance.
Procedure
Remove any batteries and turn the
power switch from RESET/OFF to
ON to IR/PULL. Each position
should have a definite stopping point.
Inspect for broken or missing knob.
Install batteries per paragraph 2-6 and
check IR source (and momentary IR
source, if so equipped) functions by
following the operating instructions in
paragraph 2-25.
Check the highlight cutoff with day-
light or bright room light (not fluores-
scent light) by placing the objective lens
cap on the objective lens. Turn the
goggles ON and observe that the sys-
tem cuts off within 70 ±30 seconds.
Location
Check/
Service
Wired Body
Housing
Cont.
Interv
al
Before/
After
Table 2-2. Preventive Maintenance Checks and Services for the NVG -
Continued.
Item
No.
3.
Cont.