Night Optics Falcon 6x Gen 3 Gated Long-Range Night Vision Binocular - Manual (Page 98)

2-63
(6) Align the nut on the helmet’s interior strapping to the
hole and tighten the screw with a flat tip screwdriver.
(7) Attach the mount to the helmet mount bracket. Insert
the top edge of the mount under the keeper on the helmet mount
bracket and rotate downward until the latch engages (see Figure 2-
24). To release the mount from the helmet bracket, press the
release button (see Figure 2-25) and pull forward and down.
(8) Find the screw located in the lower rear, center of the
helmet. Using a flat tip screwdriver, remove the screw. Hook the
rear bracket on the lower rear of the helmet and center it over the
hole where the screw was removed.
(9) Insert the screw removed in step 8 through the hole in
the rear bracket and through the helmet.
(10) Align the nut to the hole and tighten the screw with the
flat tip screwdriver.
(11) Disengage the nape strap latch on left side of nape
strap.
(12) Don the helmet. Do not fasten the helmet chinstrap.
(13) Engage the nape strap at the nape strap latch. Tension
the nape strap for a stable fit, then install and tension the helmet
chinstrap. The brow of the helmet should be parallel to the ground
and the helmet stable on the head.
(14) Insert the top edge of the mount under the keeper on the
helmet mount bracket and rotate downward until the latch engages
(see Figure 2-24). To release the mount from the helmet bracket,
press the release button (Figure 2-25) and pull forward and down.