Night Optics Falcon 6x Gen 3 Gated Long-Range Night Vision Binocular User Manual
Page 81
2-46
NOTE
If the headmount is too loose, remove the
attached thin browpad (Figure 2-13) and replace
with either the medium or thick browpad stored in
the carrying case. Refer to paragraph 3-3(1) for
removal and replacement of the browpads.
(3)
With both hands, grasp the neck pad (Figure 2-13) and
pull the harness over your head and the neck pad down to the
back of your neck.
(4)
Holding the chin cup in position on chin, adjust both
sides of the chinstrap until you feel light pressure against your
chin. (DO NOT TIGHTEN.)
(5)
Maintain the position of the chin cup and remove any
slack from the front and rear chinstraps. (DO NOT TIGHTEN.)
(6)
Ensure that the cross-strap is not twisted and remove
slack by adjusting the vertical adjustment at the neck pad.
(7)
Adjust chinstrap and vertical adjustment until the chin
cup and headmount are in a comfortable but firm position.
NOTE
After installing the goggles, minor strap
adjustments may be necessary to achieve
comfort.
(8)
Refer to paragraph 2-21 for operating procedures.